EvoMotion engineers, manufactures, and supports custom hydraulic hangar doors for aviation, architectural, and agricultural facilities across all 50 states. One-piece panels, zero headroom loss, wind ratings to 150+ mph, and smart automation — backed by responsive engineering and service from our Florida headquarters.
Most hydraulic hangar door manufacturers ship from a single facility in the upper Midwest. That works — until you need a site visit, a fast retrofit measurement, or a door engineered for a climate the factory has never seen up close. EvoMotion was built differently: a nationwide manufacturer that engineers every door to the loads, codes, and conditions of your site, not a generic national average.
Whether your hangar sits on a Gulf Coast hurricane line, a high-altitude mountain strip with heavy snow load, a desert field that bakes at 115°F, or a Midwest ag operation, we specify the panel, hydraulic power unit, seals, and finish for that environment — and deliver it anywhere in the country.
Every door is designed to the wind, snow, and seismic requirements of your site under ASCE 7 and the applicable state or local building code — not a one-size catalog spec.
Hurricane-grade panel and header engineering for coastal and high-wind regions, including Florida Building Code and Miami-Dade NOA equivalent performance.
The single-panel design needs no interior track or stacking space, preserving full clear height and reducing new-building cost on metal-building hangars.
We replace aging bifold, counterweight, and bottom-rolling doors nationwide — often increasing usable height and width in the same opening.
Soft-start/soft-stop hydraulics, remote operation, multi-door integration, and building automation (BAS) tie-in come standard on every system.
Doors operate during power outages — essential for emergency and aviation operations — with a manual override on every system.
Private pilots, FBOs, MRO facilities, corporate flight departments, helicopter operators, and military installations. FAA Part 77 height-conscious, low-profile design.
Restaurants, breweries, fire stations, showrooms, and event venues that want a clean single-panel opening with glass, polycarbonate, or custom cladding.
Machine sheds, equipment storage, and grain and livestock buildings — wide clear spans that clear the tallest combines and sprayers in one motion.
We review your opening, building type, climate, and code requirements — new build or retrofit.
Custom panel, power unit, and header design stamped to your local wind, snow, and seismic loads.
Single-piece welded steel frame built to spec, finished and crated for shipment to your site.
Coordinated delivery nationwide with installation guidance and responsive after-sale service.
Specifications vary by application and are engineered per site. Contact us for project-specific specs.
Tell us your opening size, building type, and location. We'll engineer a hydraulic hangar door to your local loads and ship it anywhere in the country.